There are actually many types of forklifts
, electric forklifts
, reach forklifts, manual forklifts, etc., each forklift has its unique characteristics, let's say reach forklifts! In fact, Jiangsu reach forklifts can also be divided into two types, one is a stand-on reach forklift, and the other is a seated reach forklift. There are still many differences between the two forklifts. Now let's understand the difference between these two types of reach trucks. By the way, let's learn about the operation precautions of the lower reach trucks! Stand-on front-reaching forklift trucks have the advantages of no pollution, low noise, high energy conversion efficiency, and simple and convenient operation. High-level stacking operations can be carried out in a limited operating space, which is incomparable between a counterbalanced forklift and a stacker. A counterbalanced forklift of the same tonnage requires more space, while the height of stacker operations is relatively compared. Low, so to complete the high-bay stacking in the limited working space, the reach forklift is a very good choice, and the standing-drive forward type is a kind of reach forklift. Car-mounted forward-moving forklifts are supported by three fulcrums. The front two on the left and right are the load-bearing wheels, and the rear wheel is the driving wheel and the steering wheel. The stability of the three-point forklift is relatively higher than that of the four fulcrums. Almost, the walking speed also needs to be controlled within a certain range. The stand-on front-moving forklift designed this time has been optimized in this regard. It adopts four-wheel support. The rear wheel consists of a steering drive wheel and an auxiliary wheel. They are connected by a suspension mechanism, which greatly improves the forklift’s performance. Stability and shock absorption effect. Operation precautions: (1) In the use of the reach forklift, special attention should be paid to timely charging and correct maintenance of the battery. Pay attention to the method when charging the battery, not only make the battery fully charged, but also not cause the battery to overcharge. (2) In the operation of the reach-type forklift, try to minimize the use of long-term and long-distance acceleration. When the vehicle starts and the speed increases, stabilize the accelerator pedal. If the road condition is better, the vehicle will continue to accelerate. When the vehicle needs to decelerate, relax the accelerator pedal and lightly depress the brake pedal, so that the energy of deceleration can be fully utilized. If the vehicle has a regenerative braking function, the kinetic energy during deceleration can be recovered. When the vehicle is going down a slope, do not disconnect the circuit that drives the motor, and gently step on the brake pedal to make the vehicle run in a regenerative braking state, and use the kinetic energy of the vehicle down to reduce the energy consumption of the battery. In addition to the above two points of attention, there is also a very important one, that is, when our vehicles are running, do not mistake the 'forward, reverse' direction switch as a steering switch. Unless you need to decelerate urgently, don't press the brake pedal to the end. During the operation of the vehicle, when the battery power is found to be insufficient (which can be obtained from the electricity meter, the power loss indicator and other alarm devices), the battery should be charged as soon as possible to prevent the battery from over-discharging.
Jiangsu Jingxin Lifting Equipment Co., Ltd. devises a regular, independent, transparent and objective assessment mechanism to evaluate country performance.
Jiangsu Jingxin Lifting Equipment Co., Ltd.’s goal is to provide the customer with an enjoyable, honest service by satisfying individual customers practical transportation needs with a quality product.
Digging into our roots and acknowledging out heritage can be fruitful on both a high-quality and professional level of ABOUT US.