How to identify the peculiar smell and the cause of the malfunction of the electric forklift?

How to identify the peculiar smell and the cause of the malfunction of the electric forklift? This situation is generally due to electrolyte leakage or loss, because this kind of battery needs to be stored and converted by electrolyte, but when the electrolyte leaks, it will produce a pungent smell; at the same time, if the electrolyte is consumed When there is too much or loss, the forklift charger will charge the battery forcibly. At this time, the battery will overheat and emit white smoke, and the smell will be even more unpleasant. If such a problem is discovered, the electrolyte should be refilled in time and the battery should be charged. Electric forklifts have found a stale plastic smell. In this case, most of the electrical wiring is caused by overheating. Because the plastic sheath of the wire is thin, the smell is not very big. However, when the wire is short-circuited, it is often accompanied by local smoke or heat. After a long time, it is easy to cause burning and fire. Once the wire is overheated, it must be stopped immediately to find out the reason. Regardless of the smell of the wire burned, the risk index is very high. Under normal circumstances, there will be more cases of excessively high wire temperature in summer. If it is not found in time, it is easy to cause complete circuit damage, engine cylinder pull, and even spontaneous combustion of the entire vehicle. Electric forklifts find rubbery smell: this smell is the easiest to distinguish. If this kind of smell occurs, first check the belt, brake shoes and tires to see if the rubber products in these parts are loose, slippery or overheated. If it is found to be brakes or tires When the odor is emitted, the engine should be turned off and the vehicle should be stopped immediately, and then drive after the heat is dissipated. Electric forklifts find a strong burnt smell: If you smell the special smell of non-metallic materials during driving, it is generally caused by the burning or overheating of the clutch friction plate. This smelt smell will also be mixed with a burnt smell, because the material of the clutch disc is a composite of rubber and asbestos. If the clutch is used normally, there is no obvious difficulty in gearing or starting difficulties, and the smell of getting off the car comes from the rear of the car, then check whether the rear brake system is overheated. Some careless car owners drive forcibly while pulling on the handbrake, which will cause the rear brake pads to lock up and produce a burnt smell.
Jiangsu Jingxin Lifting Equipment Co., Ltd. promises that we will manufature our products in accordance with the strictest quality standards.
A detailed plan must be developed if we hope to reach your profitability goal. Once we have a certain figure in mind, Jiangsu Jingxin Lifting Equipment Co., Ltd. and our staff need to determine all the steps necessary to reach that goal and act on them.
Jiangsu Jingxin Lifting Equipment Co., Ltd. has extented its range of manufacturing scale, which satisfys customers' needs.