Daily inspection of electric forklifts
and training of safety operating procedures 1. Before each shift, check whether the wheel bolts are loose and re-tighten if necessary; check the hydraulic oil level and check the tightness of the brake switch. 2. Check the condition and tightening of wires, connectors and connections. 3. Before turning on the power, the electric key switch should be in the off position. Do not turn the accelerator or hold down the oil pump button. 4. Maintain a proper starting speed when starting, and should not be too strong; the forklift should gradually accelerate and stop during driving, try to avoid sudden braking when driving fast, and pay attention to reduce the driving speed when making sharp turns to prevent the forklift from tipping over. 5. Pay attention to the electricity meter. When the red light of the electricity meter diode flashes, it indicates that the battery has been discharged 80%. At this time, the battery should be charged immediately. 6. When the electric forklift is moving, the forklift must be decelerated when shifting the front and rear gears to prevent burning of electrical components and damage to the gears. 7. Driving and lifting should not be carried out at the same time, that is, under normal circumstances, the walking motor and the lifting motor cannot be operated at the same time, otherwise the battery discharge current will be too large, the efficiency will be reduced, and the service life will be affected. 8. Pay attention to whether the sound of the driving system and the steering system is normal. If abnormal sound is found, troubleshoot the fault in time. It is strictly forbidden to work with illness. 9. Start, turn, drive, brake and stop smoothly, slow down when turning on wet or slippery roads; slow down in advance when turning. 10. When working on poor road conditions, the weight should be appropriately reduced, and the driving speed should be reduced. 11. When the electric forklift forks the goods, lower the goods as much as possible before they can walk. The forklift should generally be carried out in a vertical position when lifting the goods. When the fork frame is raised to a high position, no people are allowed to stand under the fork frame; at the same time, according to the goods Size and size, adjust the fork spacing, so that the goods are evenly distributed between the two forks to avoid partial load. 12. The load should not exceed the specified value when forklifting. The forks must be inserted under the goods and the goods should be evenly placed on the forks. A single fork tip is not allowed to pick up objects. Pay attention to the surrounding conditions during operation to avoid collisions and collisions. When forks and objects are to be lifted, they must be stable. After the objects are placed firmly, they should be lifted and lifted. 13. Pay attention to pedestrians, obstacles and potholes when driving; no people are allowed to stand on the forks, and no people are allowed on the truck. 14. People are not allowed to stand on the forks or walk under the forks; do not carry unfixed or loosely stacked goods, and be careful to carry large-sized goods. 15. Do not allow the forklift to be charged until the forklift is unable to move. This will shorten the battery life; at the same time, do not allow the tool to approach the two stages of the battery to avoid sparks or short circuits.
Jiangsu Jingxin Lifting Equipment Co., Ltd.'s products, whether interim or permanent, comply fully with all appropriate producing regulations.
Visit Jiangsu Jingxin Lifting Equipment Co., Ltd. for the best in supplies: Jingxin forklift.
Jiangsu Jingxin Lifting Equipment Co., Ltd. has never conceded on the quality and the services of the products which provided to the customer.