During the handling of factory materials, we will use all-
electric stackers. Now this kind of electric truck has become the main material handling equipment. With the use of more and more electric series material equipment, safe operation has also become People are very concerned about the problem, which safe operation methods should be paid attention to in the operation? The editor will sort out a few points for you here: 1. All-electric stacker truck operators are not allowed to drive under the influence, overweight or speeding, and no emergency Brake, make sharp turns. All-electric stackers are prohibited from entering places where solvents and flammable gases are stored. 2. The safety device of the all-electric stacker must be complete and intact, the components are sensitive and effective, and the technical performance is good. It is strictly forbidden to drive the stacker with diseases. Usually, the all-electric stacker must be maintained regularly and all components must be carefully inspected. 3. Maintain the standard driving state of the all-electric stacker. When the fork is off the ground, the fork is 10-20 cm away from the ground. When the all-electric stacker stops, the fork is lowered to the ground and travels; driving on poor road conditions During operation, its weight should be appropriately reduced, and the driving speed of the all-electric stacker should be reduced. 4. If the electric controller is out of control during the driving of the fully electric stacker, the main power supply shall be disconnected in time. 5. Special attention should be paid to timely charging and correct maintenance of the battery during the use of the all-electric stacker. Pay attention to the method when charging the battery, not only make the battery fully charged, but also not cause the battery to be overcharged; when the battery is in a state of depletion, the battery must be charged for many times, and then the battery can be restored to normal; check the battery often Whether the distilled water is sufficient, and if it is not enough, add distilled water in time. 6. In the operation of the all-electric stacker, try to minimize the use of long-term and long-distance acceleration. When the all-electric stacker starts and the speed increases, stabilize the accelerator pedal. If the road condition is better, the stacker will continue to accelerate. When the stacker needs to decelerate, relax the accelerator pedal and lightly depress the brake pedal. This can make full use of the energy of deceleration. If the all-electric stacker has a regenerative braking function, the kinetic energy during deceleration can be recovered. When the vehicle is going down a ramp, do not disconnect the circuit of the full-electric stacker's drive motor, and gently step on the brake pedal to make the full-electric stacker run in a regenerative braking state, and use the kinetic energy of the vehicle's downward movement to reduce battery consumption. energy consumption. 7. When the fully electric stacker is running, do not mistake the 'forward, reverse' direction switch as a steering switch. Unless you need to decelerate urgently, don't press the brake pedal to the end. During the operation of the vehicle, when the battery power is found to be insufficient (which can be obtained from the electricity meter, power loss indicator and other alarm devices), the battery should be charged as soon as possible to prevent the battery from over-discharging. When the all-electric stacker is transporting materials, you must not drive at high speed, and must be slow, because if you tell it to drive, it will often take emergency braking; otherwise, it will cause huge friction on the brake assembly and drive wheels and shorten the brakes. The service life of the assembly and driving wheel may even damage the brake assembly and driving wheel. When the fully electric stacker is not in use, please put the forks down to prevent the piston rod of the cylinder from being exposed to the air for a long time and rust; the driving wheel and front wheel should be ensured that there are no debris such as broken steps; power supply is maintained Disabled.
Clouds of material handling lifting equipment failures surround the world of industrial lifting devices in particular, simply because people don’t pay as much attention to the ABOUT US as they should do.
If you are looking for warehouse storage equipment ABOUT US, we have plenty of them in our store. We have goods lifting equipment and many others. Visit Jingxin forklift to know more.
To offer abundant options of product is an important factor to a company, such as ABOUT USmaterial handling racks to afford high-quality products for customers.